DIG420 - Digimat E-Training - Structural & Material Engineering
Length:
4 * 3 hours
Pre-requisites :
Basic theoretical knowledge of material constitutive models (elasticity, elasto-plasticity) is advised. Good knowledge in ABAQUS or ANSYS is welcome.
Topics:
- Introduction to the Digimat Graphical User Interface.
- Definition of a composite material in Digimat-MF.
- Material database management and automatic calibration of Digimat materials in Digimat-MX.
- Coupling of Digimat with FEA code in Digimat-CAE. Introduction to the micro solution procedure micro.
- Mapping of fiber orientation tensors between two dissimilar meshes in Digimat-MAP.
- Introduction to designing RVE (representative volume element) for two phase composite microstructures using Digimat-FE.
- Exporting the RVE into Abaqus or Ansys to run a finite element analysis on the material and post-processing of the results in Digimat-FE.
- Guided exercises to implement the different procedures presented during the course.